Please help i'm a beginner in pascal - Programmers Heaven

Howdy, Stranger!

It looks like you're new here. If you want to get involved, click one of these buttons!

Categories

Please help i'm a beginner in pascal

sleepygunsadsleepygunsad Posts: 2Member
CAN ANYONE HELP ME START WRITING THIS PROGRAM IN PASCAL.... I DONT KNOW HOW TO START WITH THE ARRAY AND ADDING VALUES...... PLEASE HELP

PROBLEM SOLVING

1. Declare 2 arrays a.Carmodel b. Category
2. Fill or populate the arrays within the program ie assign values to each position in the array, use the data from below.
3. Declare 3 constants: catA, catB and catC to hold 1000, 600 and 400 respectively.


CARMODEL ARRAY

HC NISP NISSB MITSL CHEV SUB MAZ PEUG MER


CATEGORY ARRAY

B B C C C B B B A


5. Rationale: the program starts and declares the 2 arrays and 3 constants and puts data in them .The user is then asked to enter the model of a car he can decide to enter END which should stop the program however if he enters any other value the program continues.

The program proceeds to check whether the user entered a valid model, to do this it checks through all the 10 containers of the CARMODEL array by implementing a loop(For1 to 10) and comparing each time the user value with the array value. If the person did not enter a valid model the program gives an error message and goes straight to asking for another model to check again.
If it is found at say position 3 then this position is recorded by assigning the loop position counter to some declared variable

Comments

  • PredictorPredictor Posts: 17Member
    What have you written so far?


    -Will Dwinnell
    [link=http://matlabdatamining.blogspot.com/]Data Mining in MATLAB[/link]

  • sleepygunsadsleepygunsad Posts: 2Member
    Honestly i really dont know how to start, i think if i figure out how to start with adding the arrays and storing the values to them, i think i would be able to continue.......... below is a guideline as how i think the program should run, its like i have it mapped out in my mind but cant wirte... sigh :

    These are the steps

    Declare arrays, constants and variables to be used.
    Initialize variables
    Ask for model and store
    Check whether Model=
  • _Atex__Atex_ Posts: 163Member
    I suggest that you read through some pascal tutorials first...
Sign In or Register to comment.